headerimage

MSR-I
Switching amplifiers for inductive contacts

Service intended: Switching amplifier for inductive contacts to DIN 19234 for industrial applications where no protection against explosion is required.
 

hr
Downloads
Technical Details
Operation Manual
Declaration of conformit
Technical Data
Case
Polyamide 6,6, green
Case dimensions
B x H x D :50 x 75 x 100 mm
Mounting
Snap mounting on rail: 35 mm to EN 50022
Weather protection
IP 20 to EN 60529
Wiring
Screwed connections, Cable cross section : 0,5 ... 2,5 mm2
Power supply
AC voltage : 230 V / 50 - 60 Hz / 22 mA
                 : 115 V / 50 - 60 Hz / 51 mA
                 : 24 V/ 50 - 60 Hz / 43 mA
DC voltage : 24 V / 30 mA
DC voltage output
for external units
Power supply AC : 24 V DC +/- 10 % / 20 mA
Power supply DC : auxiliary energy 1,4 V / 50 mA
Control signals
No load voltage : approx. 10 V DC
Short circuit current : 4,5 mA ± 10 %
Switching threshold : 1,8 mA ± 10 %
Output impedance : 2200 Ohm, 100 nF ± 10 %
Outputs
Potential free change-over contact
Pull in delay : 20 ms
Drop out delay : 20 ms
Breaking capacity : 1860 VA
Breaking voltage : 250 V, 50 Hz / 100 V DC
Breaking current : 8 A AC / 0,5 A DC
Permissible temperatures Tmin / Tmax
Ambient temperature: 0 ... 70°C
Optional extras
see Technical Details page 15.0202